Plumber in Marietta, GA

Shut down water to home and drain system. Pull and remove old leaking and non functional shower cartridge. Installed new shower cartridge and test for proper operation

Shower diverter replacement What is CUSTOMER? They were experiencing low water pressure coming out of the showerhead in the master bathroom shower and the handle was also leaking so therefore, I recommended to replace the shower cartridge on the inside of the shower. It took about the handle, took apart the trim plate and remove the old bonnet nut and then wiggled out the cartridge put grease all in the shower body valve to ensure proper fitment. In addition to that make sure everything was nice and tight install the new blue cartridge the prior one the O-rings on the inside were getting stuck with inside so there should be no issues with that moving forward Once installed took a video showing that is no longer leaking from the handle and more importantly the water pressure is back to normal . Had to locate the water meter to turn off the water to the home. It is next to the utility box out in the front yard. No leak after installation.

Customer had customer provided faucet to install after holes were drilled in countertops. gave options for install, and to install customer provided basket strainer after installing both items checked for leaks and proper function.

We determined customer got two defective Kohler cable waste and overflow drain assembly We cut drywall behind the two bath tub for access , replaced two tub waste and overflow assembly. Not included drywall repair , we tested with water all the way to overflow make sure no leak anywhere.

Customer wanted to replace multiple faucets during home renovation. Gave multiple quotes for various replacements. Replaced widespread faucets in upstairs master bath, kids bath and downstairs hall bath after replacements checked for leaks and proper function. Will return to install other items once items arrive. Explained to customer about exterior overflow assemblies.

For this customer, we went through the house to do our annual inspection took a look at their brand new tankless. Everything looks good with that. Their water pressure is at 60 psi however I did recommend lowering the main shut off valve to a more accessible location and go towards the walljust so it’s accessible for everybody. What I also recommend is the Aldi shut off valves at the home or all the push connect style in I recommend either replacing them with all brand new compression style or threaded connections for the shut off valves rather than the push connect style in additionally, we did our camera scope of the sewer line and at 37 feet we ran into a problem. Where the paper separated from each other, and then there is a root intrusion a little bit backwards of where the problem is so therefore, I recommended that we did that up and repair that section of pipe before it becomes a bigger problem at this time, the customer wants to look over their financials and see what works be

I did our annual plumbing inspection for this homeowner, took a look at all bathrooms, two fulls, one half. All the shut off valves have been replaced at some point they are all 1/4 turn. Everything in the kitchen is new for the plumbing system, the washing machine box is newer. Water heater is from 2019, we did flush the heater, the t&p has some oxidation and corrosion on the valve itself so I gave an estimate for that, With that in mind the water pressure is normal, major of the home is in good shape in terms of the fixtures and supply, the dwv will need some attention at some point due to the fact that it is cast iron & pvc partially. Recommend to get that repiped in pvc. The water supply is all copper.

Replace shower drain trim. If any additional work is needed there will be an additional charge. Customer stated that he was attempting to replace tub drain piece and it broken off. Attempted to remove broken piece but couldn’t and stated that piping will need to be replaced. So went ahead and remove waste and over and installed new piping. Offsetted drain for proper fitment. Also installed new drain trim pieces in brush nickel. Tested work and all tested fine with no leaks. Cleaned up work area.

Customer wanted price to scope sewer line with camera. Gave customer pricing for both cleanout inspection and pull and reset. Spent around 10 min searching for the cleanout through the landscaping and didn’t see anything evident. Customer was hesitant to pull toilet to run camera until speaking with the owner first about liability for the pull and reset. Waived dispatch fee and spoke with Hunter about checking call logs because customer said he was already given pricing over the phone for the inspection prices. Informed customer if this is the case that we will review the calls.

Did site inspection/ consultation for tub and shower drain issues, quoted waste and overflow replacement work today

Customer reported water, pulling at base of toilet. After consulting with the tenant, we identified a potential blockage. We communicated findings and options to the landlord, who approved pulling the toilet and running the camera inspection. Upon inspection, we found standing water approximately 5 feet downstream from outside cleanout. Camera inspection also shows roots that infiltrated left side of pipe however, main issue is further down line without clearing line, we are unable to determine the underlying issue of the line holding water. customer declined next steps on figuring out what is going on with pipe.(Chen plumbing has identified a drainage issue, recommended a repair, and the customer assumes full responsibility for any future issues, backups, or damages.) we properly reset toilet and flushed approximately 20 times to confirm no leaks work is tested and complete. Attached is a video of the sewer line

Call for toilet leaking in basement ceiling. Arrived and met with Ms. Paula. She noticed water stains and wet ceiling tiles in the basement this week, she had guests over this Tuesday and mentioned that on of them said the toilet did feel loose. I inspected the basement ceiling and removed (and disposed of at Ms. Paula’s request) five ceiling tiles affected by sewage. Subfloor showed no moisture or damage, and no sewage remains. Inspected toilet and found left side had incredibly loose bolt with saw marks. Toilet was loose and unsecured. Removed toilet and installed the American standard toilet provided by Ms. Paula. New toilet, wax seal, supply line. Applied silicone to base and advised to please not get wet or apply chemicals for 24 hours. During this work Ms. Paula and I also discussed concerns with copper pipes and the pinholes, water quality, and preparing for a fridge replacement. I have provided an estimate for the installation of. Whole home water filtration system, a frid

Customer had a hose bib on the rear of the home that was dripping. Initially gave a quote to replace found that half-inch line went into slab and might make install more difficult and unpredictable for price. Gave customer option to repair instead replaced the hose bib bonnet and tested work to ensure proper function and no leaks. None issues were found.

Customer stated that fridge had low water pressure. Pulled refrigerator out. Tested to see if it was on the incoming side of the waterline and found that coming to the fridge. Water pressure is fine. Stated to customer to replace water filter for refrigerator to see if that fixes issue. Also noticed that customer didn’t have the thermal expansion tank and recommended customer to get one installed. Will send estimate to do so.

Checked garage ceiling wet , appears to be leak might from shower door area , recommend customer use water restoration company

Customer wanted to replace 50 gallon gas water that was located on the third floor of home. Replaced with Rheem 50 gallon gas heater. Did not replace pan used existing pan. After replacement checked for leaks in proper function of heater. Pressure is at 50 psi.

Call for water on floor in kitchen. Inspection revealed that the pressure regulating valve has failed. This failure has led to damage to the following: -Dishwasher, resulting in water damage to floors. -Potfiller connection inside wall, resulting in water damage to floor. -Damage to water heater and thermal expansion tank -left side vanity faucet in master bathroom -right side vanity faucet and shut off valve in master bathroom -Water filtration system has been damaged. -Seized shut off valves for washing machine Due to extent of damage I have recommended reliable restoration be contacted to assist with restorative work. Today we replaced the pressure regulating valve and shut off valve for the home. I am leaving estimates for the work required.

This customer came out to their house because they had a toilet that wasn’t flushing in the toilet only was able to clear it with the 6 foot auger and pushed down whatever was stuck in the toilet following that I used in toilet bowl cleaner to clean the toilet from any debris that was stuck inside of there to make sure it was nice and clean Once finished took a video of it flushing to ensure that it was properly working at this time there are no further issues was not able to check water. Customer also has some widespread faucets that are not installed correctly. I recommend installing brand new ones in case something breaks on trying to revert back to it the proper handles

Explained to customer nothing is wrong with fire log installation by Bylen

Call for pump not working in break room. Met with Ms. Marlyn. She states the pump for the break room sink is not functioning, leading to the sink and the dishwasher not draining. Inspection revealed a 3-4 year old liberty ejection pump system has failed. Bypassing did activate pump, but discharge was inconsistent. Power supply appears adequate and consistent. Drain line is approximately 8-10 foot rise, and horizontal run has adequate fall. Vent line is dedicated, not admittance valve. Check valve functioning well. Ms. Marlyn mentioned cleaning bird feeders in the sink, and this was consistent with clumps of bird seed inside pump basin. I replaced unit and advised that mesh strainers may help extend the life expectancy of the pump. While on site I also discussed water heater. A serial number lookup places this water heater at 30 years old. Signs of failure present, and I recommend replacing the unit as soon as possible. I also discussed the benefits of our home maintenance plan, a

No water upon arrival. Customer stated yesterday morning the water would not come out anymore. After checking all shutoff valves found none being turned off. Informed customer that the main line could be frozen or the meter could be faulty. Informed customer we could dig up the main line and cut it to see if the meter was working properly. Gave customer estimate, customer declined estimate

Customer had a leak coming from a 1/4 inch plastic line behind the refrigerator. Due to the age and condition, can’t safely use any push to connect or compression fittings on that line. Gave customer option to cut the wall and run a new line to a new stop. Customer declined work at this time. Customer declined work at this time. Removed dispatch fee.

For this customer, we were called out for water, not being onto the home. I came out to the residence to find out that the waterline to the house has been turned off due to the CUSTOMER the reason it was turned off is a factor of that the waterlines had frozen, causing no water to pass through any of the fixtures, and the customer wanted to take the precaution of making sure nothing explodes in the home because all their waterlines are in the attic, they turned off the water and they wanted a professional to come out to ensure that there’s no issues with the waterlines I couldn’t find any issues. Any leaks with the waterlines in their current state. The customer is all set with that however when I was checking the water pressure on the water heater, I noticed a faint smell of gas so I decided to test it with a bubble solution on the sediment trap is where I was smelling it from and there was a gas leak on the brass nipple of the sediment trap so therefore I recommended we go ahead and

This customer he had a pipe on his water heater tankless outside units. He has two eyes outside. They are from 2007. I strongly recommend he replaced both units due to the fact of how old they are. They are almost 20 years old however they still work would I recommend is to swap them out for either a navien or a Rianni, however, the customer just wanted the pipe fixed at this time the hot and cold cold water lines had popped and split so therefore I installed a new section of pipe on hot and cold lines had to bend back the cover just a tad, the customer was OK with it. I was able to put the screws back for the skirt. In addition to that I reformed the installation of the pipes to ensure that it would not happen again at this time. Water is back on the unit, so is the gas tested the tankless before we had left to ensure that the unit was still working at this time, there are no leaks. Water pressure is at 55 psi

Came out for a high water bill. Met with homeowner who described what was going on. We confirmed there was a leak at the meter. Shut main shut off before the PRV and confirmed the leak stopped, indicating leak was somewhere inside the home. Used leak detection equipment and isolated point of leak to underneath the downstairs bathroom floor. Received approval to jackhammer the slab and dig down to the line. First spot we found the pipe but not the leak. Was getting a strong signal with the leak detection under the vanity. Removed the vanity and jackhammered underneath, no sign of the leak. We realized the signal we were getting with leak detection equipment was due to the leak under the slab spraying onto the drain line which was echoing under the slab and giving false positives. Followed pipe and broke another hole into the slab in front of the toilet. We were able to locate leak on a 3/4 copper water pipe, leak was due to corrosion in the side of the pipe. Cut out leaking sectioned an